MAX-M10N-10B GPS for Breadboard

(No reviews yet) Write a Review
SKU:
1776
  • MAX-M10N-10B GPS for Breadboard
  • MAX-M10N-10B GPS for Breadboard
$45.00

Description

Schematic / PCF8563 / 1375 RTC 

     The 1776 module is a hardware super set of the 1375 GPS RTC using a MAX-M10N-10B GPS receiver with USB connectivity and a NMEA sentence to I2C slave translator all in a plug in form factor for use on wireless breadboards.  The I2C slave has the same register layout as the PCF8563 real time clock for use as a high accuracy RTC along with the navigation data parsed out for easy access.

     To maintain GPS fix data during power cycling, a 220nF super capacitor backs up the M10N RAM for approximately 3 hours on a 2 minute charge. 3 hours is approximately the time it takes for all satellites currently in view to move past the horizon. This RAM retention allows the module to reestablish a location fix within a few seconds after a power interruption.

     The -10B version of the MAX-M10N family provides flash memory to allow firmware updates over the USB interface or breadboard connector and also includes an extra SAW bandpass filter on the RF front end to reject near band interference from other RF sources to ease its use with cell phone transmitters and the like.

Power:

  • The module operates from an input from 3.3 to 5.5VDC
  • Internal power rail is 3.3VDC

Interfaces:

  • USB Mini-B connection to GPS TXD, RXD and I2C slave control
  • GPS TXD and RXD (Logic level)
  • GPS Fix and PPS outputs
  • I2C slave SCL, SDA and Interrupt#
  • I2C slave Monitor and 10mS timing
  • I2C slave NMEA parsing flags on ICSP pins
  • I2C slave ICSP programming connections

Indicators:

  • Yellow PPS indicator: Flashes at 1 pulse per second as soon as a GPS fix has been established
  • Orange I2C slave monitor indicator: Flashes at 5Hz when active and 2Hz when in standby during M10N firmware updates
  • Green fix indicator: Flashes at 10Hz while waiting for a fix to be established and solid after a fix is aquired

Antenna:

  • The GPS antenna connects to a vertical SMA connector
  • The 1776 module supports both passive and active GPS antennas using an on board antenna power switch and DC block inductor
  • The antenna input is protected against ESD damage with an ultra low capacitance TVS diode

 

View AllClose